About SMOK TFV12 Beast Tank 6ml
SMOK is a vaping company, which was established in 2010 and is based in Shenzen that has taken the vaping world by storm. This company is known for their innovation, resulting in the first atomizer having dual coils. The company is highly regarded as being the most advanced in the industry, and is known for their R&D team, which is meticulous in coming up with new advances.
The TFV12 by SMOK helps in producing large vapors apart from TFV4 and TFV8. The tank has a diameter of 27mm and comprises of V12-T12 coils, VT12-X4(Quadruple Coils) and V12-Q4 coils (Quadruple coils stacked). The tank has a capacity of 6ml and will suit people who are looking for regular vaping sessions. In terms of performance, the SMOK TFV12 is amazing.
SMOK TFV12 Beast Tank - 6ml
Product Instructions
Parameters
Size: 27 x 70mm
Capacity: 6ml
Material: SS
Thread: 510
TFV12 Tank comes with
Type A:
- 1 x TFV12 Tank
- 1 x V12-T12 0.12ohm duodenary coils (pre-installed)
- 1 x V12-X4 0.15ohm quadruple coils
- 1 x V12-Q4 0.15ohm quadruple coils
- 1 x replacement glass
- 1 x User manual
- Spare parts
Type B:
- 1 x TFV12 Tank (pre-installed V12-RBA coil)
- 1 x V12-RBA-T (triple coils)
- 1 x replacement glass
- 1 x Single coil Silicone adapter
- 1 x User manual
- Spare parts
Simple packing. Customary Packing from the factory, the packing is subject to change without notice.
- It doesn't come with liquids, you shall buy separately.
- 510 thread.
- It is compatible with V12 RBA Coil and V12 series coils.
- You can download certificates.
Features
V12 Engine, King's sword
Cloud Beast King
Large Capacity
Special glass material drip tip
Top fill system
RBA building
Operation Guide
How to fill with e-liquid:
1. Hold the tank with one hand, and use another to press top cap and move it counterclockwise.
2. Add e-liquid through the slot, and pay attention not to drip it into the central airflow tube.
3. Close the cap carefully and firmly. Then let it stand for several minutes to get the organic cotton completely saturated. 
RBA/RBA-T Building:
1. Before starting make sure your hands are clean.
2. Taking RBA apart.
3. Installing the pre-wrapped coil. Place the coil between the posts and wrap the ends around the screws and tighten up, once all in place make sure the coil is fixed in the center and lined up with the air hole, and make sure the coil is NOT touching the base.
4. Position and cut the ends of wire off.
5. Cut a strip of cotton and make sure it's not too much, and not too little.
6. Insert the cotton, and place it in the middle.
7. Cut the cotton at an angle. Make sure it's not too short and not too long.
8. Wet the coil with your e-liquid and adjust the cotton.
Warning: Coils must be checked for resistance before they are fired on a device, and re-checked periodically to ensure the resistance remains the same.
